Christie DLV1400-DX User Manual page 105

013-100199-03
Downloaded From projector-manual.com Christie Manuals
1. TURN THE LAMP OFF
Press (power) to turn the lamp off. Allow the cooling fans to stop
automatically (within approximately five minutes) before proceeding with Step 2.
This wait period is also required to allow the lamp to sufficiently cool before
handling.
2. UNPLUG THE PROJECTOR
When the cooling fans have stopped, turn the projector's main switch off, and
unplug.
Always power down and unplug the projector prior to
servicing. Allow the lamps to cool before handling
3. REMOVE THE LAMP DOOR
Protective gear required. Wear a face shield.
Using a #2 Phillips screwdriver,
remove the two (2) screws
securing the lamp door, which is
located at the rear of the projector
below the input panel. See Figure
4.2.
4. RELEASE THE LAMP LOCK
Pull out and turn the lamp lock lever, which is located to the left of the lamp
module, and turn it ¼ turn counter clockwise to the "unlock" position. See Figure
4.3.
Figure 4.3. Release the Lamp Lock
WARNING
WARNING
Figure 4.2. Open Lamp Door
Section 4: Maintenance
4-7.