Troubleshooting The Unit; Machine/Copying Problems - Sharp MX-B200 Operation Manual

9

TROUBLESHOOTING THE UNIT

This chapter describes misfeed removal and troubleshooting.
For problems with the printer function or the scanner function, see the Help file for
the printer/scanner driver.

MACHINE/COPYING PROBLEMS

If any problem occurs, check the list below before contacting your authorised service
representative.
Problem
Unit does not
operate.
Blank copies
Copies are too
dark or too light.
Dust, dirt,
smudges
appear on
copies.
Striped copies
Paper misfeeds
frequently.
Downloaded From ManualsPrinter.com Manuals
Possible cause
Unit plugged in?
Power switch on?
Side cover closed
securely?
Front cover closed?
Is the original placed face
down on the document
glass or face up in the
SPF?
Is original image too dark
or too light?
Is the unit in the
automatic exposure
mode?
Is the unit in the photo
exposure mode?
Document glass or SPF
dirty?
Original smudged or
blotchy?
Is transfer charger clean?
Non-standard paper
used?
Paper curled or damp?
Pieces of paper inside
unit?
Paper guides in the paper
tray not set properly?
Too much paper in the
paper tray or multi-bypass
tray?
Solution
Plug the unit into a grounded
outlet.
Turn the power switch on.
Gently close the side cover.
Gently close the front cover and
then close the side cover.
Place the original face down on
the document glass or face up in
the SPF.
Adjust the exposure manually.
Adjust the automatic exposure
level.
Cancel the photo exposure mode.
Clean regularly.
Use a clean original.
Clean the transfer charger.
Use standard paper. If using
special papers, feed the paper
through the multi-bypass tray.
Store paper flat in the wrapper in a
dry location.
Remove all pieces of misfed
paper.
Set the guides properly depending
on the paper size.
Remove excessive paper from the
tray.
71
Page
Start
Guide
7
Start
Guide
Start
Guide
26, 27
28
29
28
69
–
70
9
–
80
9
10, 13
10, 12