Advertisement
Fine tuning
1）Make a homing for the printer.
Unlock the motor, manually move the extruder to the three positions of the hotbed shown in the
2）
picture. At this moment the nozzle tip is already very near to the hot bed because of previous coarse
tuning.
4. Put a piece of A4 paper between the extruder and hotbed. If there is a little bit friction when you
pull the paper back and forth, the distance is proper. Otherwise you need to adjust the screw in
this corner of the hotbed to slightly lift or lower the hotbed.
Shenzhen Getech Technology CO.LTD
www.geeetech.com
Advertisement
Need help?
Do you have a question about the Me Creator and is the answer not in the manual?
Questions and answers