Geeetech Me Creator User Manual page 18

If the homing and heating tests are normal, next you need to test the running of X, Y, Z axis and
extruder motor in Move Axis option. At the same time you need to observe if the running direction
of the motor is correct or not. For example, the extruder involves extrusion and withdrawing. If the
motor direction is opposite, the extruder can not feed normally.
X，Y axis can move at 10mm,1mm or 0.1mm.
Z axis and Extruder can only move at 1mm or 0.1mm.
For the printer, you need to check whether the extrusion is normal or not. Please set a reasonable
temperature depending on the melting point of filament, then test the feeding at 1mm or 0.1mm.
1） Choose CD>Control>Temperature>Nozzle to set extruder temperature.(generally it is the
melting point of the filament)
2） When the temperature of extruder reaches the melting point of the filament, begin the
extrusion at 1mm or 0.1mm. Check if the extrusion is fluent or not. If not, please refer to the
FAQ.
Shenzhen Getech Technology CO.LTD
www.geeetech.com