Advertisement
Shenzhen Getech Technology CO.LTD
www.geeetech.com
Note: If the operating system is Mac OS, please set the baud rate as 115200. Meanwhile, you need
to do debugging for the motor direction of the printer again after re-uploading the firmware.
Open the firmware in Arduino 1.0.1, change the baud rate of firmware to 115200 in
Configuration.h file.
After modification, re-upload the firmware. About how to burn the firmware, please refer to the
FAQ.
Advertisement
Need help?
Do you have a question about the Me Creator and is the answer not in the manual?
Questions and answers