Table of Contents
Advertisement
DISPLAY MESSAGES
If one of the following messages appears in the display, take prompt action as instructed by the message.
Message
ENTER YOUR ACCOUNT
NUMBER.
A MISFEED HAS OCCURRED.
2-SIDED COPIES CANNOT BE
MADE ON THIS PAPER TYPE.
REMOVE PAPER FROM THE
<*>TRAY.
CLOSE THE <**> COVER.
PLEASE EXTEND BYPASS-TRAY.
COVER SHEETS MUST BE THE
SAME SIZE AS THE COPY
PAPER USED.
TONER SUPPLY IS LOW.
CHANGE THE TONER CARTRIDGE.
CHECK THE TONER CARTRIDGE.
THE DOCUMENT FEEDER IS
DISABLED.
SELECTED PAPER TRAY IS
PROHIBITED. PLEASE SELECT
ANOTHER PAPER TRAY.
PLEASE CHECK THE PAPER
SIZE OF TRAY <***>.
ADD STAPLES.
PLEASE REMOVE PAPER FROM
THE STAPLER COMPILER.
MEMORY IS FULL. PRESS
[START] TO BEGIN COPYING OR
[CA] TO CANCEL.
58
Cause and solution
Auditing mode is enabled. Enter your account number.
Remove the misfeed as explained in "MISFEED REMOVAL".
This appears when you attempt to make two-sided copies on
special paper that cannot be used for two-sided copying. Cancel
two-sided copying or change the paper.
The indicated output tray is full. Remove the output from the tray.
(<*> indicates the tray that is full.)
The indicated cover is open. Close the cover. (<**> indicates the
cover that is open.)
When copying from the bypass tray, be sure to pull out the bypass
tray extension.
When adding a cover, load paper in the bypass tray that is the
same size as the paper in the tray selected for copying.
The toner cartridge must be replaced soon.
The toner cartridge is out of toner. Replace the toner cartridge.
Make sure that the toner cartridge is installed correctly.
The RSPF has been disabled in the key operator programs. Use
the document glass.
This appears when a tray is selected that has been prohibited in
"TRAY SETTINGS" in the custom settings.
The tray's paper size setting is different from the actual paper size.
Load the correct size of paper. The tray is indicated in <***>.
The finisher is out of staples. Replace the staple cartridge as
explained in "STAPLE CARTRIDGE REPLACEMENT".
Paper remains in the stapler compiler. Remove the paper.
The memory becomes full while scanning originals. Press the
[START] key (
) to copy only the originals that have been
scanned, or press the [CLEAR ALL] key (
) to cancel the job.
Page
56
64
15, 27
-
-
18
48
72
72
72
22
53
17
73
70
-
Advertisement
Table of Contents
Troubleshooting
