Olivetti d-Copia 2301 Operation Manual page 90

The procedure for using the staple sort function is explained below.
1
Place the original (p.6).
2
Touch the [OUTPUT] key.
2-SIDED COPY
OUTPUT
3
Touch the [STAPLE SORT] key.
OUTPUT
OFFSET
SORT
STAPLE
SORT
GROUP
4
Select the staple position.
top left two lower left
staple staples staple
5
Touch the [OK] key.
OK
CENTER TRAY
SADDLE
PUNCH
STITCH
6
Select the number of copies and other
copy settings, and touch the [START]
key ( ).
When the [STAPLE
SORT] key is selected,
the offset tray is
automatically selected.
Output to the center tray
is not possible.
Select top left staple, two
staples, or lower left
staple as appropriate for
the original. For one
upper left staple when
the original is a size such
as 11" x 17" or 8-1/2" x
14" (A3 or B4) in the
portrait orientation, select
the lower left staple (
7
Using the RSPF
Copying begins after all pages are scanned.
8
Using the document glass
Place the next page on the document glass and
press the [START] key (
pages have been scanned and then touch the
[READ END] key on the panel.
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
If the memory becomes full while the pages are being
scanned, "MEMORY IS FULL. PRESS [START] TO
BEGIN COPYING OR [CA] TO CANCEL." will appear
in the display. To copy only the pages that have been
scanned to that point, press the [START] key (
cancel the job and clear the scanned pages from
memory, press the [CLEAR ALL] key (
To increase the number of pages that can be
Note
scanned into memory, increase the memory
allocation in the key operator programs or
install more memory. (See "Key operator's
guide".)
).
). Repeat until all
READ-END
). To
).
79g