Mitsubishi SRK18CL Technical Manual & Parts List page 19

⑤ Securing the indoor unit to the installation plate
Installation plate
Wall
Indoor unit base lower latch
•
How to remove the indoor unit from the installation plate
ⓐ Push up at the marked portion of the indoor unit
base lower latch, and slightly pull it toward you.
(both right and left hand sides)
(The indoor unit base lower latch can be removed
from the installation plate)
ⓑ Push up the indoor unit upward. So the indoor unit
will be removed from the installation plate.
⑥ Drainage
Arrange the drain hose in a downward angle
Avoid the following drain piping.
Higher than specified The drain hose
Pour water to the drain pan located under the heat exchanger, and ensure that the water is discharged outdoor.
When the extended drain hose is indoor, securely insulate it with a heat insulator available in the market.
Since this air conditioner has been designed to collect dew drops
on the rear surface to the drain pan, do not attach the power cord
above the gutter.
Removal and installation of the front panel
Removing
① Remove the air inlet panel.
② Remove the 5 set screws.
③ Remove the 4 latches in the upper section.
④ Move the lower part of the panel forward and puch
upwards to remove.
Installing
① Do remove the air filter.
② Cove the body with the front panel.
③ Install the 4 latches in the upper section.
④ Tighten the 5 set screws.
⑤ Install the air filter.
⑥ Install the air inlet panel.
Indoor unit
Latch
(2 locations)
Installation
plate
CAUTION
Wavy
tip is in water.
Pipe accommodating section
Set screws

- -
Installation Steps
Pass the pipe through
the hole in the wall,
and hook the upper
part of the indoor unit
to the installation plate.
Gently push the lower
part to secure the unit.
The marked portion of the
Indoor unit bese lower latch
Go through all installation steps and check if the drainage is
all right. Otherwise water leak may occur.
Odor from
the gutter
The gap to the ground The drain hose
is 5 cm or less. tip is in the gutter.
Gutter
Wall
'12 • SRK-T-125
latch