Raymarine a65 Operation Instructions Manual page 171

Navigating to a location on the chart
From the chart application:
1. Select the required location on-screen.
The chart context menu is displayed.
2. Select Goto Cursor.
Navigating to the cursor position on the chart
using the menu
From the chart application:
1. Position the cursor at the desired destination on
the chart.
2. Select Menu.
3. Select Navigate.
4. Select Goto Cursor.
Cancelling navigation to a waypoint
1. Select any position anywhere on-screen.
The waypoint context menu is displayed.
2. Select Stop Goto.
3. Alternatively, in the chart application, go to: Menu
> Navigate > Stop Goto.
Note: Once navigation is no longer active, the
waypoint symbol returns to its normal state, and
the dashed line between your vessel and the
waypoint is removed.
Arriving at a waypoint
As your vessel approaches a waypoint, the waypoint
arrival alarm is triggered.
With the Waypoint arrival warning displayed:
1. Select OK.
Once the alarm is acknowledged:
• the Dialog is closed and the audible alarm is
silenced.
• if navigating a route then the next waypoint is
selected.
Note: You can set the radius (distance) of the
waypoint arrival circle which is used to trigger the
waypoint arrival alarm.
Chart application
Changing destination during active navigation
Having initiated a Goto, you can change your
desired destination by initiating a new Goto.
Note: To use this feature when connected to a
non-Evolution autopilot, Pilot integration must be
Off.
During active navigation (excluding following a
route):
1. Select the new destination.
2. Open the context menu.
3. Select Goto Cursor or Goto Waypoint
Cross Track Error (XTE)
Cross Track Error (XTE) is the amount of deviation
from your intended route or waypoint, expressed as
a distance.
D11764-2
In the event that you steer off-track, you can go
straight to your target by resetting XTE.
Resetting Cross Track Error (XTE)
While following a route in the chart application:
1. Select the route.
The route context menu is displayed.
2. Select Restart XTE.
Resetting XTE results in a new course from the
current vessel position to the current target waypoint.
This does not affect your saved route.
You can also reset the XTE from the Navigate Menu:
Menu > Navigate > Restart XTE.
XTE
D11765-2
D12295-1
171