Table of Contents
Advertisement
STEP2
ASSEMBLY
Step 2-A
Step 2-B
708
D
STEP2-A). Remove the Undercarriage Cover (704, 705) by carefully lifting pedal
Assembly and removing each piece one at a time. Be careful not to snap
Plastic push pins when taking apart. Verify that rear incline frame holder
(206) is securely tightened to Main Frame (112).
STEP2-B). Attach Incline Frame Set to the Main Frame, and hold the Incline Frame
Holder – Front (708) to the Incline Frame (109), secure using Allen head
CAP Bolts (511) with Spring Washer (517) on the Incline Frame Holder.
Don't fully tighten Allen Head CAP Bolt (511) until STEP2-D
STEP2-C). Rotate the Incline Frame (109) to align the bolt holes with the mating bolt
Holes in the Incline Transmission Tube-Front (110).
Assemble the Incline Transmission Tube-Front (110) to the Incline Frame
(109).
STEP2-D1). Firstly, tighten the Allen Head Bolt (507), and make sure again that
already fully was matched here.
STEP2-D2). Then fasten the Nylon Nut (508) by 8mm Allen Key (D) and Wrench (F).
Fully tighten the Allen Head Bolt (511) by 8mm Allen Key.
112
112
705
705
511
507
508
Step 2-C
F
109
704
109
C
517
511
http://www.yowzafitness.com/
Step 2
507
708
517
511
511 X4
517 X4
507 X1
508 X1
13
Advertisement
Table of Contents
