Reinstall Kick Plate - Jenn-Air JDRP548W Installation Instructions Manual

7. Put a control knob onto the valve stem of the burner you
want to adjust.
8. Turn the control knob to LO and, using a butane extension
lighter, light the burner.
9. Remove the control knob.
10. Use a ¹⁄ " x 4¼" flat-blade screwdriver to adjust the flame
8
height. Tighten screw to reduce flame height. Loosen screw
to increase flame height.
NOTE: When you are converting to LP gas, the screw
should be tightened down completely on the single output
valves. The dual output valve should not be adjusted.
A
A. Single flame burner adjustment screw (on right side of valve)
B. Dual flame burner adjustment screw (on left side of valve)
11. When finished adjusting the flame height, put a control
knob back onto the valve stem and turn off the burner.
12. Remove the control knob.
13. Replace the round gasket.
14. Repeat steps 6 through 13 for any other burners that
need adjustment.
15. Lift up on the control console and set it back into place.
For a proper fit, the flange of the control console must
hook over the lip on the front of the range cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
16. Check that the control console is flush with the top edge
of the range.
17. Replace the 2 screws on each side of the control console.
18. Replace the control knobs.
19. Replace burner grates.
20. Test the flame by turning the control from LO to HI,
checking the flame at each setting.
1. Align shoulder screw mounting holes with shoulder screws
on range.
2. Push kick plate down against front of range until the top
screw holes are aligned with the mounting holes on the
front of the range.
3. Reattach screws to the top of the kick plate.
A
B
A
A. Flush with range top

Reinstall Kick Plate

B
D
A. Kick plate
B. Reattach these screws.
C. Top screw hole
D. Shoulder screw mounting hole
C
17