Installation Problems - Oki B6100 User Manual

7-22 Oki B6100 User Guide
Solving 550 Sheet Feeder Problems

Installation Problems

Simple oversights during installation may cause problems when you first use the paper feeder.
If the paper feeder is inoperative after you have installed it, use the following procedure to
check several possible causes.
NOTE: The printer automatically recognizes an option after the option is installed. The printer driver does
not. You must enable (activate) the option in the printer driver after the option is installed.
The steps you will follow vary according to both your operating system and your installed printer
driver. Here are the general steps you will follow.
1. Turn the printer off by pressing the [ O ] on the power switch on the right side of the
printer.
2. Remove and then reinstall the feeder.
3. If the feeder is still inoperative after reinstallation, remove it from the printer so you can
run tests on the printer alone.
4. Print a few sheets of paper through the main paper tray or the front tray to make sure the
printer is still operational.
• If the printer is operational when the feeder is not attached, contact either your sales
representative or a service technician and report your problem.
• If the printer is not operational when the feeder is not attached, refer to
Messages and Error Messages" on page
return to
Select the driver you want to work with.
Locate the printer properties section within the printer driver.
Use the pulldown window to select the option.
Activate the option.
"Installing the 550 Sheet Paper Feeders" on page 7-4
5-31. After correcting the printer problem,
to reinstall the feeder.
"Warning
Oct 02