Testing The Offset Catch Tray - Oki B6100 User Manual

Testing the Offset Catch Tray

After installing the offset catch tray, use the following test procedure to verify that it is operat-
ing correctly.
1. Turn the printer on by pressing the [ I ] on the power switch on the front left of the printer.
2. Once the printer has warmed up and displays the "Ready" message on the control panel
display, use any software application to print a few sheets to the offset catch tray.
NOTE: The printer automatically recognizes an option after the option is installed. The printer driver does
not. You must enable (activate) the option in the printer driver after the option is installed.
The steps you will follow vary according to both your operating system and your installed printer
driver. Here are the general steps you will follow.
3. If the feeder does not feed paper or if the control panel displays an error message, refer
to"Solving Offset Catch Tray Problems" on page
Oct 02
Select the driver you want to work with.
Locate the printer properties section within the printer driver.
Use the pulldown window to select the option.
Activate the option.
Oki B6100 User Guide
Testing the Offset Catch Tray
9-10.
9-9