Safety Instructions (Don't Stick Your Hand In The Toaster!) - Blizzard Lighting KAYO.MORPH Manual

SAFETY INSTRUCTIONS
• This fixture falls under protection class I, this fixture must be earthed!
• This product is intended for indoor use only.
• Make sure that you are connecting to the proper voltage, and that the line voltage you are
connecting to is not higher than that stated on the decal or rear panel of the fixture.
• Avoid direct eye exposure to the light source while it is on.
• To prevent risk of fire or shock, do not expose fixture to rain or moisture.
• The minimum distance between light output and the illuminated surface must be more
than 10 meters (32.8 FT).
• Do not touch the device's housing bare hands during its operation (housing becomes hot).
Allow the fixture to cool approximately 20 minutes.
• If the fixture has been exposed to drastic temperature fluctuation (e.g. after transporta-
tion), do not switch it on immediately. The arising condensation water might damage your
device. Leave the device switched off until it has reached room temperature.
• During the initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective.
• The lamp has to be replaced when it is damaged or deformed due to the heat. Fast on-off-
cycles (e.g. 10 min. on/10 min. off) will reduce lamp life.
• Always disconnect the fixture from AC power before cleaning, removing or installing the
fuses, or any part.
• For replacement use lamps and fuses of same type and rating only.
• Make sure there are no flammable materials close to the unit while operating.
• The unit must be installed in a location with adequate ventilation, at least 20in (50cm)
from adjacent surfaces. Be sure that no ventilation slots are blocked.
• ALWAYS secure fixture using a safety chain. Use its carrying handles while transporting.
• DO NOT operate at ambient temperatures higher than 104°F (40°C).
• In the event of a serious operating problem, stop using the unit immediately. NEVER try
to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage.
• NEVER connect the device to a dimmer pack.
• Make sure the power cord is never crimped or damaged.
Caution! There are no user serviceable parts inside the unit. Do not open the
housing or attempt any repairs yourself. In the unlikely event your unit may
require service, please contact us at www.blizzardlighting.com/support.
Page 4
Kryo.Morph™ User Manual - Rev. A (c) 2016 Blizzard Lighting, LLC