Buell 2006 P3 Service Manual page 266

HOME
7751
2
7750
6
7755
8
1. Float
2. Float pin
3. Fuel valve
4. Wireform clip
5. Needle jet holder
6. Needle jet
7. Main jet
8. Slow jet
Figure 4-13. Carburetor- Bottom End
3. See Figure 4-13. Remove float (1) and fuel valve (3).
Carefully slide clip (4) and fuel valve (3) from tab on float
(1). Remove wireform clip (4) from groove in fuel valve
(3).
1
4
3
5
4.
5.
7
6.
7.
7763
1
1. Main jet
2. Slow jet
3. Fuel valve bore
Figure 4-14. Carburetor Housing
See Figure 4-14. Using slot at top, turn main jet (1) with
flat tip screwdriver to unthread from needle jet holder. If
necessary, hold hex on needle jet holder with a 5/16 inch
wrench to prevent rotation.
Using a 5/16 inch wrench, turn hex on needle jet holder
to unthread from main jet bore.
See Figure 4-13. Turn carburetor right side up to drop out
needle jet, which is loose in main jet bore.
See Figure 4-14. Insert thin bladed flat tip screwdriver
into slow jet bore, and using slot at top of slow jet (2),
unthread to remove.
2006 Buell P3: Fuel System
2
3
4-17