Buell 2006 P3 Service Manual page 124

HOME
INSTALLATION
1. See Figure 2-52. Connect remote reservoir.
a. If removed, attach remote reservoir to frame using
screw. Tighten to 12-15 in-lbs (1.4-1.7 Nm).
b. If removed, attach reservoir hose to master cylinder
with clamp.
7703
Figure 2-52. Remote Reservoir
2. See Figure 2-53. Apply LOCTITE 243 (blue) to both
screws. Attach master cylinder to frame with spacers
between master cylinder and footrest support. Tighten to
48-72 in-lbs (5-8 Nm).
11 1
WARNING
Use only new copper banjo washers (See Parts Catalog
for Part No.) with D.O.T. 4 brake fluid. Earlier silver banjo
washers are not compatible with D.O.T. 4 fluid and will
not seal properly over time. Failure to comply may
adversely affect braking ability and lead to brake failure
which could result in death or serious injury.
11 1
WARNING
Avoid leakage. Be sure gaskets, banjo bolt(s), brake line
and master cylinder bore are clean and undamaged
before assembly. (00322a)
2-36 2006 Buell P3: Chassis
WARNING
WARNING
7704
1
3
3
1. Banjo bolt (metric)
2. Screw (2) (metric)
3. Spacers
4. Rubber boot
5. Rod adjuster
6. Locknut
7. Clevis
Figure 2-53. Master Cylinder Mounting
2
2
4
5
6
7