Primary Chain - Buell 2006 P3 Service Manual

HOME

PRIMARY CHAIN

ADJUSTMENT
See Figure 1-22. Buell Blast Models are shipped with a
spacer between the primary chain limiting screw and the lock-
nut. The spacer is used to quickly get proper adjustment dur-
ing production. This spacer should be removed and discarded
at the first adjustment interval.
7790
3
1. Chain limiting screw
2. Spacer (discard after initial adjustment is made)
3. Jam nut
Figure 1-22. Adjustment Nut with Spacer
1. See Figure 1-22. Back-off jam nut (3) and chain limiting
screw (1).
2. Remove spacer (2).
7789
Figure 1-23. Chain Limiting Screw without Spacer
2
Be certain to use Inch-Pound Wrench. Chain adjuster
shoe can be damaged by excessive force.
7791
1
Figure 1-24. Tightening Chain Limiting Screw
3. See
lbs (2.7 Nm).
4. Back-off chain limiting screw 3/4 turn (4 1/2 "flats").
5. Hold chain limiting screw while tightening jam nut.
IMPORTANT NOTE
Figure 1-24. Tighten chain limiting screw to 24 in-
2006 Buell P3: Maintenance
1.13
1-27