Makita CL070D Instruction Manual page 5

Clean out fine dust from prefilter. Next, remove filter, and
lightly tap to dislodge dust.
Reassembly
1
010027
Put on filter until it is fully in position on the cleaner unit.
NOTE:
Make sure filter is put on straight without being
•
peeled back. If filter is put on incorrectly as shown
in diagram, dust will get into motor housing, and
cause motor failure.
1
010028
Connect prefilter. At this time, make sure to twist prefilter
so that securing lip is firmly locked into cleaner unit.
2
1
010029
010030
1. Filter
1. Filter
1. Prefilter
2. Securing lip
5
Connect capsule. Align projection on capsule with
projection on handle and then firmly twist capsule in
direction of arrow until it is secured.
010031
1
3
010032
NOTE:
Always remove dust ahead of time, as suction
•
power will be reduced if there is too much dust in
cleaner.
Always be sure to check that both filter and prefilter
•
are loaded correctly prior to using cleaner. If they
are not loaded correctly, dust will get into the motor
housing, and cause motor failure.
If the following examples occur, filter and prefilter
are not loaded correctly. Reload them correctly to
rectify problem.
Problem Examples
Example 1: Only prefilter has been loaded (no filter)
010033
1. Capsule
2. Handle
3. Projection
2
1. Prefilter
1