Linux - ATTO Technology ATTO Celerity FC-41XS Installation And Operation Manual

• If these do not solve the problem, re-flash the
storage adapter and re-install the Windows
2000/XP/Server 2003 driver. See
and updating drivers
If the devices connected to the Celerity FC
storage adapter are not accessible
1 Right-click My Computer.
2 Select Properties.
3 Select the Hardware tab
4 Select Device Manager.
5 If the Celerity FC storage adapter does not
appear under the SCSI and RAID controllers,
shut down and make sure the Celerity FC
storage adapter is properly seated in the PCI
slot.

Linux

1 Verify the celerityfc driver is loaded with the
lsmod
command. If lsmod does not show the
driver, refer to the installation instructions to
install and load the driver in
updating drivers on page 21.
2 Check the system log with the command
dmesg
. The celerityfc driver creates status
messages during initialization. Make sure that
all installed cards are properly detected and
initialized.
3 Examine the contents of the file(s)
/proc/scsi/celerityfc/X, where X is the
Configuring
on page 21.
Configuring and
a. Remove power from the PC.
b. Remove its case.
c. Check the PCI slot.
d. Replace the case.
e. Apply power.
6 Reload the driver (see
updating drivers on page 21).
7 If the adapter has been identified but there is an
exclamation point (!) on the listing, right click on
the listing and select Uninstall.
8 Reboot the system and repeat the installation
process.
9 If problems persist, contact your authorized
ATTO Technology representative.
adapter's host number. This file contains details
such as link status, connection speed and
discovered devices.
Note
Advanced users only. Modify the driver
makefile to enable debugging information.
Upon loading, the celerityfc driver displays
detailed debugging information which may
help troubleshoot the problem.
Configuring and
26