Table of Contents
Advertisement
Quick Links
ATTO Technology, Inc.
Installation and Operation Manual
ATTO ExpressPCI FCSW
64-bit PCI-to-1-Gigabit FC Host Adapter, SW optical SC interface
ATTO ExpressPCI FC 2600
64-bit PCI-to-1-Gigabit FC Host Adapter, HSSDC interface
© 2003 ATTO Technology, Inc. All rights reserved. All brand or product names are trademarks of their
respective holders. No part of this manual may be reproduced in any form or by any means without the
express written permission of ATTO Technology, Inc.
10/2003
Document Control Number: PRMA-0259-000MD
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ATTO Technology ExpressPCI FC 2600
Summary of Contents for ATTO Technology ExpressPCI FC 2600
-
Page 1: Atto Expresspci Fc
64-bit PCI-to-1-Gigabit FC Host Adapter, HSSDC interface © 2003 ATTO Technology, Inc. All rights reserved. All brand or product names are trademarks of their respective holders. No part of this manual may be reproduced in any form or by any means without the express written permission of ATTO Technology, Inc. -
Page 3: Table Of Contents
5 Troubleshooting ... 9 General suggestions Windows 2000/XP Windows NT Macintosh Appendix A Standards and compliances ... i Appendix B Fibre Channel accessories ... ii Appendix C SCSI host adapter selection guide ... iii Appendix D Contact ATTO Technology, Inc..iv... -
Page 4: Atto Expresspci Provides Fibre Channel Solutions
Solaris and Macintosh® OS, OS X ❖ RAID kits available ❖ SNIA Fibre Channel host adapter API support ATTO Technology ExpressPCI FC 3321 Installation and Operation Manual Advanced SCSI support ❖ Exclusive Advanced Data Streaming (ADS ) Technology support ❖... - Page 5 FC 3342 Fibre Channel ports Optical interface SW, LC, SFP Copper interface Max. transfer rate 400 MB/sec per channel 2, 3 Class transfers Full duplex 66 MHz only 66/33 MHz PCI compatible 133 MHz PCI-X compatible 64-bit only 64- and 32-bit PCI compatible ®...
-
Page 6: Fibre Channel Is A Key Technology For Storage
DMA bus master Allows a peripheral to control the flow of data to and from system memory by block as opposed to allowing the processor to control the data by bytes (PIO or programmed I/O) 3 ATTO Technology ExpressPCI FCSW and FC 2600 Installation and Operation Manual The Fibre Channel architecture is structured as a hierarchical set of protocol layers. - Page 7 Term Definition fabric A Fibre Channel switch or two or more Fibre Channel switches interconnected to physically transmit data between any two N_Ports on the switch or switches Fibre Channel F_port A port in the Fibre Channel fabric where a N_port may attach FL_port A port in the Fibre Channel fabric where a NL_port may attach in an arbitrated loop frame...
-
Page 8: Hardware Installation And Initial Configuration
Please keep a reference copy of the number in a safe place or write in the space provided below. WWN:_______________________ 5 ATTO Technology ExpressPCI FCSW and FC 2600 Installation and Operation Manual Installation WARNING ATTO ExpressPCI host adapters contain components that are sensitive to electrostatic discharge (ESD). -
Page 9: Initial Configuration
Mac OS X ATTO ExpressPCI Configuration Tool cable type cable size multimode 50 micron unequalized copper equalized copper ATTO Technology provides a variety of utilities for adapter configuration as described in the ATTO ExpressPCI Utilities Installation and Operation Manual. connector duplex SC optical HSSDC... -
Page 10: Installing/Updating Device Drivers And Firmware
Continue the installation of the operating system. The Windows NT installation may request the Express FC driver disk again. 7 ATTO Technology ExpressPCI FCSW and FC 2600 Installation and Operation Manual version) during system boot and the Device Manager (driver version) -
Page 11: Mac Os X Driver Installation/Update
Reboot the PC. During the reboot process, an ATTO Technology banner will announce that the host adapter was detected. Enter Control-F when prompted to begin the set-up utility. This must be done within a few seconds after the banner appears, or you will not be able to enter the utility. -
Page 12: Troubleshooting
This chapter contains solutions for the most common problems you might encounter. If you need additional assistance, please refer to the ATTO Technology web site (www.attotech.com) or contact an ATTO Technology authorized representative. General suggestions ❖Check each cable connection on every device. -
Page 13: Macintosh
If it has been identified, click on the Drivers Tab to see if the ATTO ExpressPCI host adapter driver has been started. It will say Started in the right hand column of the window. If the ATTO ExpressPCI host adapter driver appears but is not started, check on the device status. -
Page 14: Canadian Standards
Failure to adhere to the above restrictions could result in a modification that is considered an act of “manufacturing” and will require, under law, recertification of the modified product with the U.S. Food and Drug Administration (ref. 21 CFR 1040.10(i)). i ATTO Technology ExpressPCI FCSW and FC 2600 Installation and Operation Manual ______... -
Page 15: Appendix B Fibre Channel Accessories
10 m. 50/125 optical cable (LC to SC) ADAP-MIAS-BLK Media Interface Adapter (MIA) Short Wave A variety of Fibre Channel and SCSI products are also available from ATTO Technology. Please contact your ATTO sales representative for product descriptions and part number information. Fibre Channel solutions... -
Page 16: Appendix C Scsi Host Adapter Selection Guide
Appendix C SCSI host adapter selection guide ATTO Technology offers a number of SCSI and Fibre Channel solutions for storage. The following chart compares the features of ExpressPCI SCSI host adapters. Supported platforms: Sun Solaris; Linux; NetWare; SCO Unix; Windows 2000, 95/98, NT, and Macintosh OS and OS X. -
Page 17: Appendix D Contact Atto Technology, Inc
Eastern Standard Time 8:00 a.m. to 8:00 p.m., or by e-mail and web site 24-hours a day. ATTO Technology, Inc. 155 CrossPoint Parkway Amherst, New York 14068 (716) 691-1999 • voice (716) 691-9353 • fax http://www.attotech.com ATTO Technology can also be reached via e-mail at the following addresses: Sales Support: Technical Support: sls@attotech.com techsupp@attotech.com...
Need help?
Do you have a question about the ExpressPCI FC 2600 and is the answer not in the manual?
Questions and answers