ATTO Technology ATTO Celerity FC-41XS Installation And Operation Manual page 11

Celerity FC-22XH
The Celerity FC-22XH is a Fibre Channel storage
adapter which uses embedded hub technology to
provide four external connections to two
independent FC channels. The hub technology
helps simplify SAN fabric design and provides
more capabilities than found in a typical adapter.
The FC-22XH allows you to solve cost and
configuration issues in workgroup and complex
SAN designs. Several users may share Fibre
Channel connections to maximize the value of
each channel without the added expense of using
additional adapters or PCI expansion slots. The
FC-22XH design provides reduced total cost of
ownership (TCO).
These capabilities are provided without
sacrificing link quality. The onboard hub digitally
retimes all signals to reduce jitter (poor signal
quality) to attached devices. Port bypass circuitry
automatically detours around unused or
malfunctioning ports.
Hardware specifications
• Four external ports connect to two independent
FC channels
• 2.125-Gigabit data transfer rates per channel
• 400 MB/sec. maximum full duplex throughput
per channel, shared between ports
connected to each channel
• Supports all FC topologies: direct fabric,
arbitrated loop and point-to-point
• Flash ROM for easy field upgrades
• Simultaneous multi-protocol support
• ANSI Fibre Channel: FC-PH, FC-FCP,
FC-FCP2, FC-AL, FC-AL2, FC-PLDA,
FC-FLA, IETF-IPFC
Advanced FC capabilities
• Supports SNIA HBA API
• On-demand, automatic negotiation
between 2-Gb and 1-Gb Fibre Channel
• Supports Target and Intitiator modes
• Supports Windows FDMI and WMI
• Exclusive Advanced Data Streaming
TM
(ADS ) Technology
PCI bus specifications
• 64-bit, 133 MHz PCI-X
• 64/32-bit, 100/66/33 MHz PCI compatible
• PCI 2.3 compliant
• 3.3V PCI signaling only
Environmental & physical specifications
• Conforms to PCI full form factor standards
• Length: 6.600 inches
• Height: 3.800 inches
• Operating Temperature: 0-45ºC (32º-113ºF)
• Storage Temperature: -40º to 70ºC (-40º to
158ºF)
• Relative Humidity: 5 to 95% non-condensing
• 3.3V@2.0A (max.)
• 100 lf/m (minimum) airflow recommended
External connectivity
• Easy-to-install connection plate
• Up to four shortwave optical LC SFP pluggable
transceivers
• Two optical LC SFP transceivers included
• External LEDs indicate on-line and speed status
for each channel
Software specifications
• Windows XP, 2000, Server 2003
• Red Hat Linux (2.4 and 2.6 kernel)
• SUSE Linux (2.6 kernel)
• Mac OS X
6