Removing The Print Server Card - Epson Stylus Pro 4000 Printer Manual

130 | Installing the Optional Print Server Card
WARNING: The card will be
hot after printing. Make sure
you allow the card to cool
before handling it.
5. Slide the card along the slots inside the compartment. Push it in firmly
to fully insert the connector into the printer's internal slot.
6. Use the two screws included with the card to secure it.
7. Connect one end of the appropriate cable to the card. Then connect the
other end to your computer's Ethernet port or hub.
8. Plug in the printer's power cord.
Once the printer is connected to your network, you need to configure it.
Turn on the printer and press the small black button on the back of the
Ethernet card. Hold it down until the printer starts printing a series of status
sheets. See the documentation that came with the print server for
instructions on configuring it for your network.

Removing the Print Server Card

If you need to ship your printer to EPSON for service, you must remove the
card.
1. Turn off the printer and disconnect the power cord.
2. Disconnect the Ethernet cable.
3. Remove the two screws securing the card.
4. Make sure the card is cool before pulling it out of the slot.
A-130