Keypad Reference; Keypad Direction - Honeywell NX series User Manual

STOP READY
I /Oterm
Keypad control
"
P1 P3
STOP READY
I/ Oterm
Control Place
Keypad
Figure 7-6. Selection of control place
7.3.3.2

Keypad reference

The keypad reference submenu (P3.2) displays and allows the operator to edit the frequency
reference. The changes will take place immediately. This reference value will not, however,
influence the rotation speed of the motor unless the keypad has been selected as the
active control place.
NOTE: The maximum difference between the output frequency and the keypad reference is 6 Hz.
The application software monitors the keypad frequency automatically.
See also 7.3.3 above.
See Figure 7-5 for how to edit the reference value (pressing the
necessary).
7.3.3.3

Keypad direction

The keypad direction submenu displays and allows the operator to change the rotating direction of
the motor. This setting will not, however, influence the rotation direction of the motor
unless the keypad has been selected as the active control place.
See also 7.3.3 above
See Figure 7-6 for how to change the rotation direction.
Note: Information on controlling the motor with the keypad is given in Chapters 7.2.1,
7.3.3 and 8.2.
Control keypad
READY
STOP
I/ Oterm
Control Place
I/O Remote
STOP READY
K eypad
Control Place
enter
Keypad
STOP
I/ Oterm
Control Place
I/O Remote
Enter button is not, however,
7
57(86)