Keypad Control Menu (M3); Selection Of Control Place - Honeywell NX series User Manual

Nx series constant and variable torque variable speed drives for induction motors

Hide thumbs Also See for NX series:

Table of Contents

56(86)

Keypad control menu (M3)

7.3.3

In the Keypad Controls Menu, it is possible to choose the control place, edit the frequency

reference and change the direction of the motor. Enter the submenu level with the

button.

NOTE! There are some special functions that can be performed when in the M3

menu:

Select the keypad as the active control place by keeping the

pushed down for 3 seconds when the motor is running. The keypad will become

the active control place and the current frequency reference and direction will be

copied to the keypad.

Select the keypad as the active control place by keeping the

pushed down for 3 seconds when the motor is stopped. The keypad will become

the active control place and the current frequency reference and direction will be

copied to the keypad.

Copy the frequency reference set elsewhere (I/O, fieldbus) to the panel by

keeping the

Note that Whilst in any other than M3 menu these functions will not work.

If in a different menu other than M3 menu and try to start the motor by pressing the START button

when the keypad is not selected as the active control place an error message Keypad Control NOT

ACTIVE will be displayed.

7.3.3.1

There are three different places (sources) which the frequency converter can be controlled from.

For each control place, a different symbol will appear on the alphanumeric display:

Change the control place by entering the edit mode with the

can then be browsed through with the

Enter

button. See the diagram on the next page.

Table of Contents

Nxs 0003 Nxs 0004 Nxs 0005 Nxs 0007 Nxs 0009 Nxs 0012 ... Show all