Parameter Copy; Contrast Adjustment; Backlight Time; Parameter Copy To Keypad - Honeywell NX series User Manual

Contrast adjustment (P6.4.4)
In case the display is unclear adjust the contrast through the same procedure as that for the
timeout time setting (see above).
Backlight time (P6.4.5)
Giving a value for the Backlight time, can determine how long the backlight stays on before going
out. Select here any time between 1 and 65535 minutes or 'Forever'. For the value setting
procedure see Timeout time (P6.4.3).
7.3.6.5

Parameter copy

The parameter copy function is used when the operator wants to copy one or all parameter groups
from one drive to another. All the parameter groups are first uploaded to the keypad, then the
keypad is connected to another drive and then the parameter groups are downloaded to it (or
possibly back to the same drive).
Before any parameters can successfully be copied from one drive to another the drive has to be
stopped when the parameters are downloaded to it:
The parameter copy menu (S6.5) embodies two functions:
Upload parameters to keypad (To keypad, S6.5.1)
This function uploads all existing parameter groups to the keypad provided that the drive is
stopped.
Enter the To keypad page (S6.5.1) from the Parameter copy menu. Push the
button to enter the edit mode. Use the
press the Enter button. Wait until 'OK' appears on the display.
READY
I/Oterm
Copy Parameters
" P4
P1
READY
I/Oterm
Up to keypad
Wait...
Figure 7-19. Parameter copy to keypad
Control keypad
Browser buttons
READY
I/Oterm
Up to keypad
Select
READY
I/Oterm
Up to keypad
OK
to select the option All parameters and
READY
I/Oterm
Up to keypad
All param.
7
73(86)
right arrow menu
CONFIRM
enter
CANCEL