Denon DN-508MX User Manual page 13

I/O Name
This window shows the names of all of your
inputs (mic/line inputs, ST inputs, and Aux
In) and zone (line outputs). Click each field
and enter a name using your computer
keyboard. Click Save to save the names.
System
•
Setting File: This field shows the currently loaded
setting file, if any. To download the current setting
file (if any) to your computer, click Download. To
upload a setting file from your computer to DN-
508MX, click Browse, find and select the file, and
then click Upload.
•
Mic/Line: For each mic/line input, select whether
the input is a microphone (Mic) or a line-level
device (Line), whether the high-pass filter should
be enabled (On) or disabled (Off), and whether
the microphone should receive phantom power
(On) or not (Off). Please note that most dynamic
microphones do not require phantom power,
while most condenser microphones do. Consult
your microphone's documentation to find out
whether it needs phantom power.
•
Source: Click each Gain menu to set the gain
trim level of each audio source. All sources have
an editable automatic gain control (AGC), which
adjusts the gain level to help reduce noise in the
signal:
Compensation Level: Click this menu to set
o
how much gain is applied after the signal is
compressed by the AGC.
Response Time: Click this menu to
o
set how quickly the AGC reacts to
audio signal.
Noise Gate: Click one of the buttons
o
to enable (On) or disable (Off) the
noise gate. When on, the audio signal
will be automatically muted if it is
below a certain volume level. This
eliminates moments during which the
source is not producing any sound
but there is still detectable noise in
the audio signal.
13