NETGEAR WAC730 Reference Manual page 63

ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Setting
Serial Number
Current Time
AP Uptime
Current IPv4 Settings
For information about how to change any of these IP settings, see
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current IPv6 Settings
For information about how to change any of these IP settings, see
IPv6 Address
Prefix Length
Dynamic IPv6 Address
Default Gateway
LAN IPv6 Link-Local
Address
DHCP Client
Current Wireless Settings for 802.11b, 802.11g, or 802.11ng
and
Current Wireless Settings for 802.11a or 802.11na
Note: The section heading depends on the configured wireless mode.
Access Point Mode
Description
The serial number of the wireless access point.
The current time. For information about how to change the time settings, see
Configure Basic General System Settings and Time Settings
The length of time since the access point became active.
The IPv4 address of the wireless access point.
The subnet mask for the address of the wireless access point.
The default IPv4 gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a DHCPv4 server on
your LAN network. Disabled indicates a static IP configuration.
The default IPv6 address of the wireless access point.
The prefix length for the address of the wireless access point.
The dynamically assigned IPbv6 address if the DHCPv6 server has the stateful
option enabled.
The default IPv6 gateway for the wireless access point communication.
This is an automatically generated IPv6 address that uses the IPv4 address in the
interface portion of its address.
Enabled indicates that the current IP address was obtained from a DHCPv6 server on
your LAN network. Disabled indicates a static IP configuration.
The operating mode of the wireless access point. One of the following modes is
indicated:
• Access Point
• Point-to-Point Bridge
• Point-to-Point Bridge with Access Point
• Multi-Point Bridge with/without client association
For information about how to change the mode, see
page 89.
Management and Monitoring
63
on page 16.
Configure the IPv4 Settings
Configure IPv6 Settings on page 72.
Configure Wireless Bridging
on page 18.
on