Connecting The Camera - Lorex LZC7092B Instruction Manual

4

Connecting the Camera

Note
It is recommended to connect the camera to your DVR and test the PTZ controls before
permanent installation. For instructions on how to setup PTZ controls, see 6 Controlling
the PTZ Camera with your DVR, page 10.
1. Connect the female 12V DC power connector on the camera to the male
12V DC power connector on the extension cable.
2. Connect the BNC video connector on the camera to the extension cable.
3. Connect the RS485 wires on the extension cable to the RS485 connector
on the camera as shown below.
1
3.1.
3.2.
#LX400006; r. 1.0/11219/11445; en-US
1
DC 12V
2
BNC
3
RS485
2
Use a philips head screwdriver (not included) to loosen the 2
screws on the RS485 connection block attached to the camera.
Insert the RS485 wires on the extension cable, matching the polar-
ity on the cables coming from the camera (red to red, black to
black). Tighten the screws on the RS485 connection block to se-
cure the wires in place.
6
5
4
4