Assembly; Power Cord And Grounding Instructions - Tunturi GO 10 User Manual

ASSEMBLY

As for the assembly of the device, we
recommend two grown-up persons. Do
not take the treadmill out of the box: use
the packing material to cover the floor on
the assembly site.
Before assembling the device, insure all
parts are present:
• Frame
• Power cord
• Assembly kit: keep the assembly
tools, as you may need them e.g. for
adjusting the equipment
In case of problems contact your Tunturi
dealer. The directions left, right, front
and back are defined as seen from the
exercising position. To avoid injury, you
must fold up the deck prior to lifting the
treadmill out of the box.
Locate the hardware bag and parts that
are listed in the chart below.
Part # Description
A Main frame and console
B Side cap
C Screw
D Washer
E Washer
F Screw
G Allen key
H Screwdriver
I Safety key
O W N E R ' S M A N U A L
Lift up the upright, then place the screws
(C) and washers (D, E) inside holes at
the bottom of the upright. Tighten them
well.
Attach the side caps (B) with screws (F)
at the bottom of the upright, and tighten
them well.
Q'ty
1
2
6
4
2
6
1
POWER CORD AND GROUNDING
1
INSTRUCTIONS
1
Plug the socket end of the power cord
into the treadmill at the left front corner.
Before connecting the device to a power
source, make sure that local voltage
matches that indicated on the type plate.
The treadmill operates at 110 V or 230 V.
GB
•
G O R U N 1 0
5