Assembly Instructions; Description (Fig. A); Package Contents (Fig. B ); Assembly (Fig. C&D) - Tunturi Cardio Fit T30 User Manual

English

Assembly instructions

Description (fig. A)

Your treadmill is a piece of stationary fitness
equipment used to simulate walking or running
without causing excessive pressure to the joints.

Package contents (fig. B )

- The package contains the parts as shown in
fig. B.
- The package contains the fasteners as shown in
fig. C. Refer to the section "Description"
‼ NOTE
• If a part is missing, contact your dealer.
Assembly (fig. C&D)
⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least
two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around
the equipment.
• Refer to the illustrations for the correct
assembly of the equipment.

Use

Master power switch (fig. E-2 #A)
The equipment is equipped with a master power
switch to shut down the equipment completely.
To start the equipment:
- Insert the mains plug into the equipment.
- Insert the mains plug into the wall socket.
- Set the master power switch to the on position.
16
To stop the equipment:
- Set the mains power switch to the off position.
- Remove the mains plug from the wall socket.
- Remove the mains plug from the equipment.
Safety key (Fig F-4)
The equipment is equipped with a safety key that
must be properly inserted into the console to start
the equipment. If you remove the safety key from
the console, the equipment will stop immediately.
- Insert the safety key into the slot in the console.
- Make sure that the clip of the safety key is
properly attached to your clothing.
Make sure that the clip is not removed from
your clothing before the safety key is removed
from the console.
Circuit breaker (Fig. E-2 #B)
The equipment is equipped with a circuit breaker
that interrupts the circuit when the electricity load
is above the maximum capacity. When this occurs,
the circuit breaker must be pressed.
⚠ WARNING
• Before pressing the circuit breaker, remove
the mains plug from the equipment.
If the equipment shuts down, proceed as follows
to restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the
equipment.
- Insert the mains plug into the equipment.
‼ NOTE
• Some circuit breakers used in homes are
not rated for high inrush currents that can
occur when a treadmill is first turned on or
even during normal use. If your treadmill is
tripping the circuit breaker (even though it is
the proper current rating and the treadmill
is the only appliance on the circuit) but
the circuit breaker on the treadmill itself
does not trip, you will need to replace the
breaker with a high inrush type. This is not a
warranty defect. This is a condition we as a
manufacture have no ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1)
and folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of
unfolding and folding the equipment.