Cleaning And Lubricating The Treadmill; Lubricate The Running Deck According To The Following Instructions; Aligning The Running Belt; Align The Belt According To The Following Instructions - Tunturi GO 10 User Manual

CLEANING AND LUBRICATING THE
FAILURE TO LUBRICATE YOUR
TREADMILL MAY INVALIDATE THE
PRODUCT'S WARRANTY!
Wipe the treadmill surfaces, especially
the handlebars and console from dust
with a damp cloth or towel. Do not use
solvents. Use a small vacuum nozzle
to carefully vacuum around all visible
components (belt, running deck, side
rails etc.). Also keep the area near
the treadmill clean. While in use,
the treadmill gathers dust that may
cause problems in the operation of the
equipment. In average domestic use (a
maximum of 60 minutes a day),
you should check the lubrication once
a month
However, lubricate the belt only if
needed. In more demanding use, the
lubrication needs be checked at shorter
intervals. This is best done before you
begin a training session. Check the
lubrication as follows:
• Ensure the treadmill is powered off!
Step on the treadmill belt .and stand
steadily where you normally run on
the belt.
• 2. Take hold of the horizontal
handlebar and push the belt with
your feet so that it slides back and
forth. The belt should move softly and
evenly, without a sound.
• 3. If you notice jerky movement or
if the belt will not slide check for
lubrication by sliding your hand under
the belt.
LUBRICATE THE RUNNING DECK
ACCORDING TO THE FOLLOWING
INSTRUCTIONS:
• Attach the nozzle of the lubrication
tube to the T-Lube S container.
• Lift the running deck and lock it.
• Position the nozzle between the belt
and the board. Try to reach the spray
as far into the center of the running
deck as possible.
10
TREADMILL
• Spray the lubricant for 2-3 seconds.
• Lower the running deck into its
normal position. Use treadmill for
your training session. Or allow the
treadmill to run for at least 5 minutes.
NOTE!
Lubricate your treadmill only with T-Lube
S silicon lubricant. Contact your local
Tunturi distributor for further supplies
of T-Lube or further information on
lubrication and maintenance.

ALIGNING THE RUNNING BELT

Monitor belt tracking during exercise and
make adjustments as needed. The belt
should run in the center of the treadmill.
Alignment is not usually needed,
provided
• The treadmill is placed on an even,
solid and horizontal surface and the
belt is correctly tensioned
• The alignment of the belt is correct
It is, however, possible for the belt to
be pushed to one side due to the user's
running style (e.g. more weight on
one foot). The alignment of the belt is
adjusted by turning the two bolts at the
back of the treadmill.
ALIGN THE BELT ACCORDING TO
THE FOLLOWING INSTRUCTIONS
• Turn the power switch on and
increase the treadmill's speed to 5
km/h (3 mph).
• If the belt drifts to the left, turn the left
adjustment bolt 1/4 turn clockwise
and the right adjustment bolt 1/8
turn anti-clockwise. If the belt drifts
to the right, turn the right adjustment
bolt 1/4 turn clockwise and the left
adjustment bolt ¼ turn anti-clockwise.
• If the belt remains centered the
adjustment is correct. If not, continue
to make small adjustments as above
until the belt is correctly aligned.
If the belt is allowed run across to
one side for long periods of time the