Ready To First Cup; Brewing Iced Beverages, Hot Water - Keurig K-Cup K3000SE Owner's Manual

Set-Up & First Brew
SECTION 1
6. The brewer will automatically fill the internal
4
fig.
hot water tank with water and then the
water will be heated. This will take about
READY - CHOSE K-CUP PACK
LIFT HANDLE
three minutes. During the priming period,
Español Français Hot
Water "HEATING PLEASE WAIT" will be displayed on
the LCD Screen.
Once the water is heated, the display will
7.
change to figure 4. Place a 10 oz. mug on the
Drip Tray Plate, then fully raise the brewer
Handle. The display will change to figure 5.
5
fig.
Lower the Handle to close the Lid over the
K-Cup ® Pack Holder. NOTE: A K-Cup
INSERT NEW K-CUP PACK should not be used for this sequence.
LOWER HANDLE
Español Français Hot
The display will change to figure 6. Press
8.
Water
"YES" and then select a size to start the
cleansing brew.
9. When the cleansing brew is complete, discard
the hot water from the mug. The brewer will
go into its idle state and will be ready to brew
6
fig. your first K-Cup ® pack.
Ready to Brew Your First Cup
NO K-CUP PACK DETECTED
CONTINUE ANYWAY?
NO YES
1. The LCD Display will be in its idle state (fig. 7).
Place a mug on the Drip Tray.
2.
Lift the Handle (fig. 8). The K-Cup
3.
7
fig.
Holder will open toward you.
4. Select a K-Cup ® pack.
READY - CHOSE K-CUP PACK
LIFT HANDLE
NOTE: Do not remove the
Español Français Hot
Water
foil lid or puncture the
K-Cup ® pack.
5. Place a K-Cup ® pack in the
K-Cup Pack Holder (fig. 9).
®
CAUTION: There are two sharp needles that
puncture the K-Cup pack, one above the
®
K-Cup ® Pack Holder and the other in the bottom
of the K-Cup ® Pack Holder. To avoid risk of
injury, do not put your fingers in the K-Cup
8
fig.
Pack Assembly Housing.
® pack
NOTE: The brewer is equipped with Cup
Sensors. If a cup is not detected the screen will
display "PLACE YOUR CUP OR SELECT CONT."
To resume brewing replace your cup.
Lower the Handle to close the Lid over the
6.
K-Cup Pack Holder.
®
7. The display will show a choice of 4, 6, 8 and
10 oz. brew sizes. Select your brew size by
pressing the corresponding button (fig. 10).
There may be a short pause prior to coffee
8.
being dispensed. The entire brew process
lasts for under one minute and ends with
a burst of air to remove all liquid from the
K-Cup pack.
®
8
Pack CAUTION: There is extremely hot water in the
®
9
fig.
K-Cup
To avoid risk of injury, do not lift the Handle or
open the K-Cup
the brew process.
9. The end of brew is indicated by
"KEURIG BREWED ENJOY."
Lift the Handle, the used K-Cup
10.
automatically ejected into the internal K-Cup
Pack Bin. When the bin requires emptying, the
brewer will display "EMPTY K-CUP PACK BIN."
Refer to page 13 for instructions.
CAUTION: K-Cup
®
11. Enjoy your first cup of Keurig Brewed
gourmet coffee, tea or hot cocoa!
10
fig.
NOTE: After brewing a hot cocoa K-Cup
we recommend running a hot water brew cycle
without a K-Cup
Your brewer may display "HEATING
12.
PLEASE WAIT" as it heats water for the
next brew cycle.
your
SELECT BREW SIZE
brew. The pump will make a vibrating sound.
8 10
4 6
This is normal.
Brewing Iced Beverages
® Pack Holder during the brew process.
Your iced tea and iced coffee taste best when fresh-brewed hot over ice.
Pack Assembly Housing during
®
1. Fill a 16 oz. cup (do not use glass) to the top with ice and place a Brew
Over Ice K-Cup pack into your brewer.
®
Select your brew size, we recommend selecting a 6oz. or 8oz. brew.
2.
Press the corresponding button to brew.
packs are
®
3. Stir and enjoy!
®
Look for the Brew Over Ice icon on K-Cup
brew over ice!
IMPORTANT: Do not brew into a cup made of glass. Doing so may
cause the glass to crack or break.
® pack will be hot.
11
fig.
®
pack,
®
READY - CHOSE K-CUP PACK
LIFT HANDLE
Español Français Hot
Water
® pack.
NOTE: Following the brew,
brewer will fill in preparation for your next
9
® packs that are specially crafted to
Brewing hot Water
Your brewer is able to produce hot water for use in
cooking, making soups, oatmeal, etc. The path of
water delivery is separate from the coffee delivery
path. One of the button options is "Hot Water".
Hot water will be dispensed as long as the button
is pressed and held (fig. 11) delivering a total
of 8 oz. max before refilling. If the button is not
illuminated, wait for heating to complete.