Page 1
K-3500™/ K3000SE CLEANING & START-UP PROCEDURE This procedure demonstrates how to properly clean ® and sanitize the Keurig K-3500™ & K3000SE brewer This procedure should take approximately 30 minutes. Tools Needed ® ® Keurig K-Cup Deep Cleaning Kit ( if available ...
Page 2
Disconnecting & Draining Turn power switch to O position Turn 90 degrees to OFF position and disconnect water line to brewer and unplug from outlet Lift handle and eject any used Open front door and remove disposal bin ...
Page 3
Draining & Removing Parts Carefully drain water from brewer using a Lift and remove drip tray large water-tight container or the disposal bin CAUTION WATER MAY BE VERY HOT ® Remove K-Cup pod holder from Pull tabs back and remove ...
Disconnecting & Removing Parts cont. Carefully use screwdriver to detach Remove pivot from one side of the pivot puncture mechanism NOTE: The pivot removal is optional as it can be cleaned & sanitized in place Cleaning & Sanitizing Place all removed parts into large container as shown below Clean &...
Page 5
Cleaning & Sanitizing cont. Use a disinfectant wipe on exterior of brewer ONLY Wipe interior of the puncture mechanism with a clean cloth ® dipped in Urnex Complete Café sanitizer ® If available, Urnex Café Wipz can be used CAUTION Sharp Needle 5 ...
Cleaning & Sanitizing Procedure Cleaning Solution ® 1. Prepare solution by adding 8 oz ( ) of Urnex Rinza concentrate to 1 gallon ( ) of warm tap water 240 ml 3.5 L or equivalent dilution 2. Mix well and use immediately 3.
Page 7
Re-assembly Pivot Install 1. Locate the holes on either side Pivot of the puncture mechanism 2. Lower pivot into puncture mechanism 3. Use screwdriver to help lock and start on one side the pivot into place 7 ...
Re-assembly cont. ® K-Cup Pod Holder Install ® Example of K-Cup pod holder and pivot installed together ® K-Cup pod holder ® 1. Lower K-Cup pod holder and snap 2. Following install, check for free ...
Page 9
Re-assembly cont. Re-insert drip tray Open main door and re-insert disposal bin Running A Cleansing Brew Plug power cord into a grounded outlet Re-connect water line and turn valve ON and turn power ON Check thoroughly for any leaks 9 ...
Page 10
Running A Cleansing Brew cont. Allow brewer to fill and heat approximately 3 minutes Running A Cleansing Brew cont. Lift and close handle Press Yes to continue ® Do NOT insert a K-Cup 10 ...
Page 11
If available, an Urnex Cleaning Cup can be used in place of one of the cleansing brews is now ready to use Procedure Complete! ® If you have any questions, please contact Keurig Commercial Technical Support: 888-287-2739 option 5 11 ...