Download Print this page
Keurig K-Slim Use & Care Manual
Hide thumbs Also See for K-Slim:

Advertisement

Quick Links

Slim
Use & Care Guide
Get the most from your new
Keurig
coffee maker
®

Advertisement

loading
Need help?

Need help?

Do you have a question about the K-Slim and is the answer not in the manual?

Questions and answers

Peta
May 13, 2025

I can’t get the descale light to turn off. I’ve tried pressing down the 8oz and 12oxz button s at the same time, also unplugging it at the mains but nothing works, even though I’ve descaled it (twice).

1 comments:
Mr. Anderson
May 21, 2025

To turn off the descale light on your Keurig K-Slim after descaling, follow these steps:

1. Activate Descale Mode: With the machine powered off, press and hold the 8oz and 12oz buttons together for 3 seconds until the DESCALE light turns solid.

2. Run Descaling Process: Press the K button to start. Run the descaling solution through the machine as instructed.

3. Rinse Cycle: After the descaling solution is used, run fresh water through the machine (without descaling solution) by pressing the K button. Repeat this until the water reservoir is empty and the "Add Water" light turns on.

4. Refill Water Reservoir: Add fresh water. The "Add Water" and "Descale" lights should turn off.

5. If Light Stays On: Unplug the machine, wait a few minutes, then plug it back in. The descale light should turn off.

This answer is automatically generated

Richard Mr. Sommerstein
January 30, 2025

Add water never comes on so it won't exit descaling modw

1 comments:
Mr. Anderson
February 10, 2025

If the "Add Water" light does not turn on during descaling mode, it may cause the brewer to overheat and shut down. This can happen if the water tank runs dry. To resolve this issue:

1. Ensure Water Reservoir is Filled – Refill the water reservoir to the MAX fill line with fresh water before starting the descaling process.
2. Reset the Thermostat (if the brewer does not power on after overheating):
- Unplug the brewer.
- Remove the bottom screws using a Phillips screwdriver.
- Locate the overheat thermostat inside.
- Use a paperclip to reset the thermostat.
- Reassemble the brewer and plug it back in.

Following these steps should help restore normal operation.

This answer is automatically generated

Steph
January 22, 2025

I turned my Kslim off and stored to move it and found it willl not come on? Not sure bc it had no issues prior I **** not sure if there’s some kind of way to turn it back on other than just hitting the power button lol. I had to ask. Thanks.

1 comments:
Mr. Anderson
February 10, 2025

Your Keurig K-Slim may not turn on after moving it because of an overheated internal thermostat. If the machine is plugged in but not powering on, you can reset the thermostat. To do this:

1. Unplug the coffee maker.
2. Remove the Phillips screws on the bottom, including two under the rubber feet.
3. Locate the thermostat reset inside the unit.
4. Use a paperclip to press the reset button.
5. Reassemble the machine and plug it back in.

This should restore power to your Keurig K-Slim.

This answer is automatically generated

Steve
January 21, 2025

Do the oz lights stay on after brewing a cup

Subscribe to Our Youtube Channel

Summary of Contents for Keurig K-Slim

  • Page 1 Slim Use & Care Guide Get the most from your new Keurig coffee maker ®...
  • Page 2 1. Power the coffee maker off while it is plugged in. 2. Press and hold the brew and 8oz buttons for 3 seconds. The 12oz button will illuminate to confirm that the High *Recyclable in select locations. Visit keurig.ca/recyclable for more information. Altitude Brewing Mode has been enabled.
  • Page 3 To replace it, orient the snaps to the water-only brew cycles. Do not insert a K-Cup® pod. indent and just snap it back onto the K-Cup® pod holder. TIP: Refer to keurig.ca/support_1 for video instructions on cleaning the entrance/exit needles.
  • Page 4: Descaling Your Coffee Maker

    • Turn off and unplug the coffee maker. STEP 1: Descaling Solution Rinse • If there is Keurig® Descaling Solution in the water reservoir, discard the contents, rinse the water reservoir thoroughly and refill with water. Pour the entire bottle of Keurig® Descale Solution into an •...
  • Page 5: Warranty

    God. register your coffee maker on keurig.ca/welcome so that your purchase information will be stored in our system. Keurig will, at its option, repair OTHER LIMITATIONS or replace a defective coffee maker without charge upon its receipt of proof of the date of purchase.
  • Page 6 E. Drip Tray Plate F. Drip Tray G. Drip Tray Base H. Water Reservoir Lid I. Water Reservoir For replacement parts, please visit www.keurig.ca Coffeehouse taste in your own home. REGISTER YOUR NEW KEURIG® COFFEE MAKER and receive a special savings offer.