Operating Instructions - Vision TC2-AMP2 Owner's Manual

ENGLISH

oPERATING INSTRUCTIoNS

1. Before turning on, please connect the system properly as shown. The Techconnect
Amp is not designed to drive a 4Ω load (i.e. 2 speakers from each output), so we
recommend only using one pair of low-impedance speakers. The speaker cable must
be unshielded with a gauge of no less than 0.75mm. THE WARRANTy WILL BE VoID If
yoU USE UNSUITABLE SHIELDED CABLE. THIS IS A LoW-ImPEDANCE AmPLIfIER. Do NoT
ATTEmPT To CoNNECT 100V LINE SPEAkERS (Normally any speakers with "t" in the part
code)
2. Set the master volume to minimum, set the input selector to the required input, then
turn the unit on and adjust to suit.
2
1. VGAf3.5mm module
2. 3-Phono module
3. TC AmP module
2
4. Bare-wire speaker terminals
5. Uk double gang surround
1. VGAf3.5mm module
2. 3-Phone module
3. DC Power
4. TC AmP module
2
5. Bare-wire speaker terminals