Table of Contents
Advertisement
Troubleshooting
TROUBLESHOOTING GUIDE
Symptoms
Lamps fail to operate?
Motor is on but fan does
not seem to be as efficient
as usual?
The extractor works normaly
but smells linger?
Product does not operate?
If you cannot eliminate the problem after following the instructions in this section, consult your
depot or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.
Technical specification
TECHNICAL INFORMATION
General
Total power consumption
Fuse
Voltage /Frequency
Cable type / section
Cable length
Lamps
Possible Cause
•
A replacement lamp is probably
necessary, but first check that the
lamp is correctly fitted into its holder.
(Remember that the lamps are not
covered by the guarantee.)
•
Power is cut.
•
Clogged filters can reduce the
product's efficiency. Check the grease
and charcoal filters (if fitted) also
ensure any venting is not obstructed?
•
Clogged filters can reduce the
product's efficiency and may cause
unwanted smells.
•
The mains fuse maybe defective or
has tripped
•
Product is not connected properly.
Exclusive to Howdens Joinery.co
Solutions
Disconnect the mains electricity supply before adjusting
or replacing the lamps.
The extractor lamps may become hot; therefore ensure
the bulb has cooled sufficiently before replacing.
Check if there is power. Check the fuses in the fuse box. If
necessary, replace or reset the fuses.
Clean the grease filters with warm water and mild
detergent, and/or replace any charcoal filters
Clean the grease filters with warm water and mild
detergent, and/or replace any charcoal filters.
Check fuses in the fuse box. If necessary, replace or
reset them.
Check all power connections.
140W
3 A
220-240 V ~ 50 Hz
0.75mm², 3 core or equivalent
max. 1.5m
G4 20W each
User manual LAM2502 LAM2503
Page _ 13
Hide quick links:
Advertisement
Table of Contents
