Table of Contents
Advertisement
* - The works are effectuated by a specialized service organization..
10. GENERAL INSTRUCTIONS
10.1. Mounting of gas appliances for domestic use must be effectuated in accordance with the project for
appliance's installation and the set of rules SP 62.13330.2011.
10.2. The appliance must be installed on fire-resistant walls (brick, concrete, with ceramic plating).
10.3. The appliance's installation and technical service must be done only by a specialized service
organization. The appliance must be connected only to the gas category that is indicated in the user's
manual and the table on the appliance
10.4. The installed appliance must be obligatory registered in the gas facilities service.
11. Handing the appliance over to the Customer
11.1. After installing the appliance, the installer must check its operation in the rated conditions. If it's
necessary the appropriate adjustments should be performed for achieving the values indicated in the "User's
manual"
11.2. After termination of mounting and adjustment works the consumer should be instructed about the
order of using the appliance:
rules of water quantity regulation;
rules of gas quantity regulation;
order of switching the appliance on and off;
Appliance treatment works, effectuated by the customer.
11.3 The mark about the instruction must be made in the Certificate of the Installation and technical
service. There should also be a mark about the appliance's installation.
.
12. Technical service
The appliance's technical service is effectuated not less than once a year by a specialized service
organization.
Works connected with technical service are not the manufacturer company's warranty liabilities and are
effectuated at the customer's cost.
The appliance's examination and treatment are effectuated by its owner.
During the technical service the following works are effectuated:
-cleaning of the main and ignition burners (including cleaning of the plug and the flame sensor);
-cleaning the heat exchanger from soot and cleaning (washing) the heat exchanger's pipes from scale
deposit (if necessary)
-cleaning and connecting the contacts;
-replacing the sealings in the gas and water systems;
User's and technical staff manual
23
Advertisement
Table of Contents
