Table of Contents
Advertisement
The appliances should be put in not more than 8 tiers during collection into stacks and transportation.
6.
safety measures
6.1. Mounting of the appliance, putting it into operation and its technical service must be performed only
by a specialized service organization. The appliance's mounting must be effectuated in accordance with the
project corresponding to the requirements of the Federal and local regulatory acts, governing the installation
of the gas-powered equipment.
6.2. Placing the appliance, pipelines, exhaust flues, smoke exhausters and other engineering equipment
should provide safety of their operation, ease of technical service and repair.
6.3. Before connecting the appliance it is necessary to do the following:
-Check the compliance of the settings indicated in the Acceptance certificate and in the table on the
appliance with the type and pressure of gas available at the place of the appliance's installation. In case of
non-compliance it is necessary to effectuate the appliance's rendering to the used type and pressure of gas in
accordance with p.7.10 (page 15)
-To make sure that the exhaust flue is correctly mounted and air-tight;
- In order to provide the appliance's correct operation and keep the warranty, it is necessary to follow the
requirements of this manual.
7 APPLIANCE INSTALLATION
The appliance must be installed by the specialized service organization. After the appliance's installation,
checking its working capacity and the appliance's owner's instructing by an employee of the organization
that installed the appliance, a mark about the appliance's installation should be made in the Certificate of
installation, technical service and repair and in the warranty coupons
7.1
Place and scheme of installation
7.1.1. The appliance must be installed in kitchens or any other heated non-residential premises according
to the project of gasification and set of rules SP 62.13330.2011.
7.1.2. The volume of the premise where the appliance is installed should be not less than 8 m
7.1.3. The premise where the water heater shall be installed must have good ventilation and constant fresh
air inflow (window or opening transom), because while the appliance is on, oxygen combustion occurs. Grids
or gap in the bottom part of the door or wall must not be tightly closed
7.1.4. The appliance must be connected to the exhaust flue with a good draught (rarefaction 1, 96...29, 4
Pа) and besides it should be located as close to the exhaust flue as possible. One of the available ways to test
the draught in the exhaust flue is presented on the scheme 4.
No draught (the candle flame
doesn't' bend) –
do not use the
appliance
Insufficient draught
(the candle flame bends)
do not use the appliance
15
3
.
Good draught
(the candle flame goes out)
-the appliance can be used
Advertisement
Table of Contents
