Mounting The Appliance - BaltGaz LUX User Manual

7.2 Mounting the appliance

7.2.1 Before installing the appliance it is recommended to remove the casing, for this it is necessary
to do the following:
a) Unscrew in the appliance's bottom part two self-threading screw fixing the casing to the carrier on
the body frame;
b) Disconnect the cable, connecting the display PCB with the electronic control board
c) Pull the casing's bottom part towards yourself, move it upwards and remove from the appliance.
If the casing or the appliance's body frame is covered with a protective polyethylene film, it is necessary
8
to remove it before installation. Also it is necessary to remove the stickers with warning notes and
advertising information from the front surface of the casing (if there are any)
7.2.2. The appliance is hanged by the mounting apertures (on the back wall) on two hooks, mounted on
the wall (hooks and dowels are included into the supply package). Position and sizes of the mounting
apertures are shown on Scheme 1, Scheme 2 (page 6). If a harness board is included into the supply
package, it is recommended to use it for marking the holes on the wall.
7.2.3 Overall and connecting dimensions for connecting water pipes, gas pipes, and pipes for removal
combustion products are presented on the scheme 1 and 2 (page 6).
18