Connecting Base Stations And Dect Manager - Gigaset N720 DECT IP Installation, Configuration & Operation

First steps

Connecting base stations and DECT Manager

To be able to make calls with your Gigaset N720 DECT IP Multicell System via VoIP, the
following conditions must be fulfilled:
u
The DECT Manager is installed
u
Your DECT Manager and base station are connected to the local network (
u
At least one base station is registered (
u
At least one handset is registered to the telephone system (
Perform the following steps in the specified sequence, first for the DECT Manager and
then for all the base stations to be installed:
§§1§§
Connect the power cable to the device and connect to the mains power supply, if
necessary.
§§2§§
Connect the base to the router/switch to access the local network and configure via
the Web configurator.
§§3§§
Fix the device to the planned position on the wall.
Please note
Your Gigaset N720 DECT IP Multicell System is supplied with sufficient power via PoE
(Power over Ethernet) if the device is connected to an Ethernet switch with PoE
functionality (PoE class IEEE802.3af ). In this case, you do not need to connect the
device to the mains power supply and step
12
£
page 17)
§§1§§
can be omitted.
£
page
£
page 18)
14)