Connection To The Drainage System; Connecting The Drain Hose - Miele DGC 6705 Operating And Installation Instructions

Connection to the drainage system

Connecting the drain hose

The drain hose should be connection to a drain trap with a
fixed hose connection point or to the trap on the sink drain
pipe.
The drain trap may not be located higher than the drain hose
connection on the appliance, to ensure a complete draining
of the waste water.
The drainage water is approx.160°F (70°C).
IMPORTANT:
Drain hose loop may be positioned at or above the flood level
of the sink or drain board to which it is connected tp provide
the proper air gap. The top end of the drain hose must not be
higher than 19 11/16" (500 mm) to where it connects to the
drain trap.
The supplied drain hose must not be shortened.
If required, a longer drain hose 24' 7" (7.5 m) is available to
purchase. This hose must not be shortened either.
We recommend using only genuine Miele hoses.
The entire hose length must not exceed 24' 7" (7.5 m).
^ Connect the drain hose to the using the hose sleeve C
3/4" (21 mm).
^ Attach the hose with the hose clamp.
Water connection
157