Grounding The Chassis - Nortel Secure Router 4134 Quick Start Manual

Nortel networks secure router quick start guide
Hide thumbs Also See for Nortel Secure Router 4134:
Table of Contents

Advertisement

36 Installing the Secure Router 4134 chassis and hardware components
Procedure steps
Step
1
2
3

Grounding the chassis

You must properly ground the Secure Router 4134 before you place it
in service. You can connect your ground wire to the grounding strip of
the equipment rack, but you must also ensure that the equipment rack is
properly grounded.
For all installations, you must provide proper grounding through a UL listed
terminal attached to the grounding location on the front panel of the router.
The grounding lug, as well as the screws and washers necessary to attach
it to the Secure Router 4134, ship in the container with the Secure Router.
Average time to install the grounding terminal: 1 minute.
ATTENTION
You must install the Secure Router 4134 in a restricted-access location. You
must limit access to the Secure Router 4134 to authorized service personnel
only.
Copyright © 2007, 2008 Nortel Networks
.
Ensure you have a Phillips screwdriver #2.
Ensure the mounting brackets are firmly installed on the chassis.
Ensure you have appropriate antistatic materials.
Nortel recommends you have two people to help lift the chassis into
the equipment rack and securing it.
Ensure your installation site meets the physical, electrical, and
environmental requirements described in
(page
61). Site location is important for the proper operation of the
Secure Router 4134. Place the unit in a clean, dry environment with
adequate air circulation. Allow 2 to 3 feet (0.61 to 0.91 m) of additional
clearance around the Secure Router 4134 for access to the cable
connectors on the front and rear panels.
Action
With two people, lift the chassis into available rack space.
Ensure that the chassis is level, and align the screw holes on the
chassis brackets with those on the equipment rack.
Insert the mounting screws. Space the screws evenly to hold the
chassis in the frame.
Nortel Secure Router 4134
NN47263-100 02.01 Standard
18 February 2008
--End--
Quick Start
"Environmental requirements"

Advertisement

Table of Contents
loading

Table of Contents