To Connect The Server To The Clan; Connecting The Server To The Clan (Optional) - Nortel CallPilot 1002rp Hardware Installation Manual

October 2006
Connecting the server to the CLAN
(optional)
Introduction
This section provides instructions to connect the server to the CLAN.
Note: The CLAN is optional. However, a CLAN is required to support
desktop and web messaging users.
ATTENTION
Media Access Control address
The MAC address is a unique number assigned to network cards and
controllers. The procedure below asks you to record the CLAN MAC
address. The MAC address is recorded on a label affixed to the back of the
chassis.

To connect the server to the CLAN

1 See the diagram on page 65 to locate the CLAN network connector.
2 Locate the MAC address label on the back of the chassis that identifies
the CLAN controller MAC address.
3 Record the MAC address on the Configuration Wizard worksheet that is
provided in the Installation and Configuration Task List
(555-7101-210)
1002rp Server Hardware Installation
Installing the server and connecting the peripheral devices
To comply with EMC radiation requirements, a Class A
hub must be located 10 m (33 ft.) away from the 1002rp
server. Shielded Ethernet cables must be used.
.
71