Table of Contents
Advertisement
RADION receiver OP
Power/Voltage
(Standby battery)
Transformer power/voltage
Current Draw
Wire Gauge
Temperature (operating)
Relative Humidity
Device testing
Wall and Cover Tamper Switch Transmits a tamper signal when someone removes the device from its
Frequency
Table 4.5: Specifications
4.4
LEDs
The repeater utilizes an external LED indicator to status the operation of the repeater. Refer to
the table below for LED descriptions.
LED Condition
On (Normal)
Off
Continuous Flash: 1 sec
rate for 5 sec
Continuous Flash: A 3-
pulse signal, followed by
a short delay after the 3
pulse
Continuous Flash: A 2
flash pattern continuous
pulse between On and
Off states with a short
delay after the 2
Bosch Security Systems, Inc.
16.5 VAC, 40VA (~)
(EN voltage range: 16.5 VAC– 18 VAC) AC Type (device)
Rated 3.7 VDC, 3050mAH EVE ENERGY CO Part No P0046-LF (Not user
replaceable). For standby battery to be operative, the tamper switch is
required to be engaged.
Power source type: A
Low battery level: 3.5V
Must meet country specific requirements
60 mA
0.65 mm (22 AWG) to 2.0 mm (18 AWG)
Functional range: -10 C to +49 (+14 F to +120 F)
EN 50130-5 Class II only: -10 C to 40 C (+14 F to +104 F)
0% to 93% (non-condensing)
To ensure proper functionality, the device must be tested at least once
every year by an installer.
base or pulls it away from the wall.
433.42 MHz
Pattern Description
–
Indicates the repeater is functioning normally.
–
Indicates there is a power failure to the repeater, or that the
receiver is not wired correctly.
–
Indicates the repeater is being powered up, and conduction
manufacturing test initializations.
–
Indicates the repeater has experienced a low battery
condition.
rd
–
Indicates an AC power failure is detected.
–
A communication failure within internal hardware
components inside the receiver
nd
pulse
Reference Guide
RADION repeater | en
19
2014.12 | 02 | F.01U.261.835
Advertisement
Table of Contents
