Handling The Remote Controller - Vivax ACP-09CH25AEL User Manual

HANDLING THE REMOTE CONTROLLER

8m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block the signals
from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the remote
controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains to prevent the sunlight from falling
on the receiver.
If other electrical appliances react to the remote controller. either move these appliances
or consult your local dealer.
Location of the remote controller.
Keep the remote controller where its
signals can reach the receiver of the
indoor unit. (a distance of 8m is allowed).
When you select the timer operation, the
remote controller automatically transmits
a signal to the indoor unit at the specified
time.
If you keep the remote controller in a
position that hinders proper signal
transmission, a time lag of up to 15 minutes
may occur.
Replacing batteries
The remote controller uses two alkaline dry
batteries (R03/LR03X2)
(1) Slide the cover of the battery
compartment, then replace the old
batteries with new ones.
(2) After step (1) is done, push the RESET button.
(3) Before replacing the battery compartment
cover, confirm that the display screen on the
remote controller displays "0:00" and that
the colon is flashing.
After replacing batteries, set the remote
controller clock.
4