Operating The Remote Controller - Vivax ACP-09CH25AEM User Manual

ON/OFF Indicator: This symbol appears when the unit is turned
3
on by the remote controller, and disappear when the unit is
turned off.
OPERATION MODE Indicator: When press the MODE button,
4
it shows the current operating mode -- AUTO
HEAT (Cooling only model without)
LOCK Indicator: LOCK display is displayed by pushing the LOCK
5
button. Push the LOCK button to clear display.
TIMER DISPLAY Indicator: This display area shows the settings
6
of the TIMER. That is, if only the starting time of operation is set,
it will display the TIMER ON. If only the turning off time of operation
is set, it will display the TIMER OFF. If both operations are set,
it will show TIMER ON-OFF which indicates you have chosen
to set both the starting time and off time.
FAN SPEED Indicator: Press the FAN SPEED button to select
7
the desired fan speed setting (Auto-Low-Med-High). You selection
will be displayed in the LCD window except the Auto fan speed.
NOTE: All signs shown in the Fig.2 is for the purpose of clear
presentation. But during the actual operation only the re-
lative functional signs are shown on the display panel.

Operating the Remote Controller

Install/Replace Batteries
The Remote Controller uses two alkaline dry batteries
1. To install the batteries, slide the back cover of the battery
compartment and install the batteries according the
direction (+and -)shown on the Remote Controller.
2. To replace the old batteries, use the same method as
mentioned above.
NOTE
1. When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote control
to malfunction.
2. If you do not use the remote controller for several weeks
remove the batteries. Otherwise battery leakage may damage
the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the
indoor unit or if the Transmission Indicator light fails to light.
4
COOL DRY
mode.
(LR03X2).