Operating The Remote Controller - Vivax ACP-18CF50AERI User Manual

Operating the Remote Controller

Install/Replace Batteries
The Remote Controller uses two alkaline dry batteries(LR03X2).
1. To install the batteries, slide the back cover of the battery compartment and install the
batteries according the direction (+and -)shown on the Remote Controller.
2. To replace the old batteries, use the same method as mentioned above.
AUTOMATIC OPERATION
When the Air Conditioner is ready for use, switch on the
power and the OPERATION indicator lamp on the display panel of the indoor unit starts
flashing.
1. Use the MODE .select button to select AUTO.
2. Push the TEMP button to set the desired room temperature. The most comfortable temperature setting are
between 21 º C to 28º C.
3. Push the ON/OFF button to start the air conditioner. The OPE- RATION lamp on the display panel of the
indoor unit lights. The operating mode is AUTO FAN SPEED is automatically set and there are no indicators
shown on the display panel of the remote controller.
4. Push the ON/OFF button again to stop the unit operation
NOTE
!
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN , HEAT and DRY
by sensing the difference between the actual ambient room temperature and the set temperature on the
remote controller.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected manually.
COOL/ HEAT (Cooling only model without) and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually over-
ride the settings by using COOL, HEAT or FAN ONLY modes.
2. Push the TEMP button to set the desired room temperature.
When in COOL mode, the most comfortable settings are 21 C or above. When in HEAT mode, the most
comfortable settings are 28 C or below.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the ON/OFF button, the operation lamp lights and the air conditioner start to operate as your settings.
Push the ON/OFF button again to stop this unit operation.
NOTE
The FAN ONLY mode can not be used to control the temperature. While in this mode, only steps 1,3 and 4 may
be performed.
DRY Operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from
。
21 C to 28 C.
3. Push the ON/OFF button, the operation lamp lights and the air conditioner start to operate in the DRY mode.
FAN SPEED is Low. Push the ON/OFF button again to stop this unit operation.
NOTE
!
Due to the difference of the set temperature of the unit and the actual indoor temperature, the Air
Conditioner when in DRY mode will automatically operate many times without running the COOL and
FAN mode.
。
。