Part Names And Their Functions; Operation Instructions - Vivax ACP-12CT35GEEI User Manual

1. Part names and their functions

CAUTION
.
Before opening the front panel, be sure to stop the
operation and turn the breaker OFF. Do not touch the metal
parts on the inside of the indoor unit, as it may result in
injury
1. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside
of the air filters.
2. Air outlet
3. Display
4. Front panel
5. Louvers (vertical blades)
•
The louvers are inside of the air outlet
6. Air inlet
7. Air filter
8. Flap (horizontal blade)
9. Cool mode lamp
10.Heat mode lamp
11.Dry mode lamp
12.Run lamp
13.LED display
14.Indoor Unit ON/OFF switch:

Push this switch once to start operation.

Push once again to stop it.

The operation mode refers to the following table.

This switch is useful when the remote controller
is missing.
Model Mode
COOL
COOLING ONLY
AUTO
HEAT PUMP
15.Signal receiver:

It receives signals from the remote controller.

When the unit receives a signal, you will hear a short
beep.

Settings changed
16.Air outlet selection switch
17.Room temperature sensor:

•It senses the air temperature around the unit
NOTE:
® If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
© The appliance shall be installed in accordance with national wiring regulations.
© An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be connected in fixed wiring. For models with a power plug, make
sure the plugs within reach after installation
.
Temperature Air flow
setting rate
25 C AUTO
25C AUTO
beep

OPERATION INSTRUCTIONS

OUTDOOR UNIT
18.Air inlet: (Back and side)
19.Refrigerant piping and inter-unit cable
20.Drain hose
21.Earth terminal:
•It is inside of this cover.
22.Air outlet
Appearance of the outdoor unit may differ from some
model