Maintenance; Technical Data - Hyundai VK 222 Instruction Manual

Function of the electric kettle is signaled with the control light A2. After boiling the appliance
switches off automatically. Before reaching the boiling point, you can switch off the appliance by
turning the A1 button to the OFF position. Always use fresh drinking water for boiling.
ATTENTION
– When heating water, the lid must be closed, otherwise the steam sensor will not be working.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to
maximum, water can flow out from the electric kettle in the bottom part of the kettle. This
does not affect safety or other functions and it does not mean any failure of the electric
kettle. In the case of tilting the electric kettle with hot water there is a risk of scalding.
Therefore do not tilt the electric kettle.
– If the kettle was removed from the stand during boiling, remains in ON position. This
means that if you put it back on the stand, it will immediately continue in heating.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the
socket! Clean the kettle only when it is cooled down! Do not use rough and aggressive
detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The casing of the
electric kettle and the heating bottom is made of top-quality stainless steel, but in common use,
impurities from water get stuck on them (water scale), particularly above the heating element. It is
not rust or another material defect of the kettle container and the appliance is not subject to
a complaint for this reason.
Cleaning the kettle
In the hard water area, it is important to do the decalcification regularly to keep the kettle in good
working condition, because too much scale inside may cause the kettle fail to work. For the best
performance of your kettle, decalcify the unit from time to time. The frequency depends on the
hardness of your tap water and how many times you have used the kettle. Decalcification will clean
the interior of the unit.
Cleaning the sieve (A7)
Take the sieve from the kettle. Clean it from possible sediments in running water using a fine brush.
Then put the sieve back in the opposite way.
This may be done in the following manner:
- Half fill the kettle with ordinary tap water.
- Add 30 ml of white vinegar to the water in the kettle.
- Boil the mixture and allow it to stand for 30 seconds.
- Repeat this process two or three. Empty, rise well and use the kettle in the normal way.
V. TECHNICAL DATA
• Input 2200 W
• Max. capacity 1.7 liters
• Weight (kg) approximately 1,0
• Protection class of the appliance I.
• Size, (cm) 23 x 25 x 16,5
• Input in off mode is 0.00 W
Expert service must do the large maintenance or to intervene into inside parts of the
appliance! Non-observance of the instructions of the manufacturer cancels the right for
guarantee repair!
20 / 26