Maintenance; Technical Data - Hyundai HYUVK106B Instruction Manual

APPLICATIONS
Unwind the necessary length of the power cord B2 from the storage space of the stand B. Place the
stand on a suitable surface, in the height of about 85 cm, out of reach of children and incapacitated
persons (see par. I. SAFETY WARNING) and plug the fork of the power cord to the electric socket.
Hold the kettle A on the handle A4. Open the lid A5 by pressing the lock button A6. Fill the kettle
with drinking water. The minimum and maximum amount of water is marked on the water gauge A3.
Close the lid by snapping. Put the electric kettle on the stand and turn it to the I position by the A1
button. Function of the electric kettle is signaled with the control light A2. After boiling the appliance
switches off automatically. Before reaching the boiling point, you can switch off the appliance by
turning the A1 button to the 0 position. Always use fresh drinking water for boiling.
ATTENTION
– When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to maximum, water
can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the electric
kettle. In the case of tilting the electric kettle with hot water there is a risk of scalding. Therefore
do not tilt the electric kettle.
– If the kettle was removed from the stand during boiling, remains in ON position.
This means that if you put it back on the stand, it will immediately continue in heating.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the
socket! Clean the kettle only when it is cooled down! Do not use rough and aggressive
detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The casing of the
electric kettle is made of top-quality plastic material and the heating bottom is made of top-quality
stainless steel, but in common use, impurities from water get stuck on them (water scale),
particularly above the heating element. It is not rust or another material defect of the kettle
container and the appliance is not subject to a complaint for this reason.
Cleaning the sieve (A7)
Take the sieve from the kettle. Clean it from possible sediments in running water using a fine brush.
Then put the sieve back in the opposite way.
Cleaning the kettle
In the hard water area, it is important to do the decalcification regularly to keep the kettle in good working
condition, because too much scale inside may cause the kettle fail to work. For the best performance
of your kettle, decalcify the unit from time to time. The frequency depends on the hardness of your tap
water and how many times you have used the kettle. Decalcification will clean the interior of the unit.
This may be done in the following manner:
Put about 50 g of citric acid into the kettle with limescale sediment. Fill the kettle half with water and
stir. After dissolving, fill it up to ¾ of maximum amount of water. Place the kettle on the stand and
turn on. Turn off the kettle before reaching boiling point, let the solution work for 10 minutes and
then pour it out. Rinse the kettle thoroughly with clean water. In case of very thick sediments, you
can repeat the process. Clean the kettle regularly!
V. TECHNICAL DATA
• Input 2200 W
• Max. capacity 1,8 liters
• Weight (kg) approximately 0,7
• Protection class of the appliance I.
• Size, (cm) 16 x 22,7 x 23,3
• Input in off mode is 0.00 W
20 / 26